Home > Products

contact us

We will store the information you have provided us. We will only use this information for the purpose of helping to answer your inquiries. We will not disclose your information to third parties. In the process of helping you, we may need to transmit your information outside the EU. Check this box to indicate that you agree to the above terms.

  • *
  • *
  • <?=$post[

    drilling into brick, anchoring a chin up bar | The .

    -six 1/4 inch drop in anchors -a hammer drill, if you don't have one, and a 3/8 inch masonry bit. Get someone to cut the pipe to your measurements and re-thread the cut end. The flanges screw onto the pipe, and voila, one chin up bar.

    Chat Online
  • <?=$post[

    Should you be buying a second-hand smartphone?

    So what's the attraction of owning a second-hand phone that's ... that is a bit optimistic. He says ... on Sunday agreed to buy Husky Energy in a C$3.8 billion all-stock deal that will combine two ...

    Chat Online
  • <?=$post[

    anchor bolts, what size masonary drill bit? - boards.ie

    anchor bolts, what size masonary drill bit been their done that. i find the threaded bar the best straight true the wall live you out.anchor bolts o good in bad block walls. not last as long as threaded bar anyway

    Chat Online
  • <?=$post[

    England beat Ireland by four wickets: second one .

    01-08-2020· 48th over: Ireland 205-7 (Campher 67, McBrine 20) The 50 partnership comes up in just 35 balls between these two, the second time they have combined nicely for the ninth wicket.

    Chat Online
  • <?=$post[

    Stress Free Anchoring: Preparation tips and .

    I like to use a rope rode on the first anchor (with a length of chain at the anchor) and our chain (primary) rode on the second anchor. As we motor forward to drop the second anchor, I leave the first rode cleated off but pull in the slack by hand and let it pile up on deck, maintaining a little tension on the line.

    Chat Online
  • <?=$post[

    Buy Drop in Anchors @ LOW Trade Prices | Tradefix .

    TradeFix Direct – UK suppliers of a MASSIVE range of Drop in Anchors in stock today. Buy online at LOW TRADE PRICES plus FREE next day DELIVERY available. Take advantage of our bulk quantity DISCOUNTS on Fixings & Fastenings products.

    Chat Online
  • <?=$post[

    SAFETY COVER SYSTEMS

    • Drill holes using 3/8" drill bit. Hole should be drilled 2-1/2" deep into masonry wall. Clear hole of any debris. Hole will be slightly deeper than anchor shaft. STEP 4: • Remove Cable Mate Wall Anchor from expansion casing. • Using the wall anchor tamping tool, tap the expansion casing into the 3/8.

    Chat Online
  • <?=$post[

    Hilti - #HiltiLive with Annie | Facebook

    To control so if you drop it get stuck into the concrete and it jumps and it wants to kick out of control The motor will cut off preventing risk of injury of the hand, arm and wrist there so I've already preset it into the drilling and sizzling because we're into the concrete and I pre drilled just a little bit in there so I'm not spending 20 minutes in the hole on this live here so I'm gonna ...

    Chat Online
  • <?=$post[

    Industrial Core Drills & Rigs for sale | eBay

    German engineered GOLZ FB23P core hand drill- includes handle and carrying case. $1,620.36. HIlti 2065218 Stop drill bit TE-CX 5/8"x2" anchor systems. $196.07. German engineered GOLZ KB110V core drill stand w/ laser pointer . $690.00. Got one to sell? Get it in front of 160+ million buyers.

    Chat Online
  • <?=$post[

    Welcome to All Metal Fasteners | Industrial .

    Big Wipes hand cleaning wipes can be as effective as soap and water at removing microorganisms from hands, ... As one of Ireland's leading stockholders of quality metal fasteners, we think you will find our range impressive and our service second to none. Contact Us. Contact Us +353 (0)1 864 3080;

    Chat Online
  • <?=$post[

    Attaching a Ledger to Concrete Block - Houzz

    25-10-2020· Any first hand experience would be greatly appreciated. ... I cannot tell you how many times I have heard the '3/8 inch should be fine, it's only a deck'. ... Wedge & drop-in anchors are specifically NOT recommended for concrete block applications on the website you link to above.

    Chat Online
  • <?=$post[

    Amazon: Simpson Strong-Tie DIABST37-SDS .

    Buy Simpson Strong-Tie DIABST37-SDS Drop-In Anchor SDS+ Power Setting Tool for 3/8": Stud Anchors ... Bosch HCSTP2061 3/8 In. x 1-1/16 In. SDS-plus Stop Bit,Silver 4.9 out of 5 stars 15. ... It also saves time as it takes about a second to install the anchor, ...

    Chat Online
  • <?=$post[

    Sticky moment: Pensioner mistakes slushy machine .

    The mask-wearing pensioner walks into the unidentified petrol station, which appears to be in Ireland, and pumps the sticky liquid from the slushy machine onto his hands thinking its sanitser.

    Chat Online
  • <?=$post[

    Build a Climbing Wall Book | Atomik Climbing .

    Option #2 - Concrete Drop-in Anchor – This anchor is a little more sensitive to install, but at a quarter of the cost of the next option, many builders choose this option because of budget concerns. This anchor can only be used in solid concrete. Drill bit size for these 3/8-16 anchors is 1/2".

    Chat Online
  • <?=$post[

    Drill Bits | McMaster-Carr

    Choose from our selection of drill bits, including over 10,200 products in a wide range of styles and sizes. In stock and ready to ship.

    Chat Online
  • <?=$post[

    Hilti - #HiltiLive with Annie | Facebook

    To control so if you drop it get stuck into the concrete and it jumps and it wants to kick out of control The motor will cut off preventing risk of injury of the hand, arm and wrist there so I've already preset it into the drilling and sizzling because we're into the concrete and I pre drilled just a little bit in there so I'm not spending 20 minutes in the hole on this live here so I'm gonna ...

    Chat Online
  • <?=$post[

    The Ultimate Anchor Watch - BoatUS Magazine

    If the boat drags, both alarms will sound, alerting you instantly. If the wind direction changes, the second device will go off but not the first, so you can start a real anchor watch. Once the boat stabilizes, enable a new set point on the second device and head back below, confident in the redundancy of the two anchor .

    Chat Online
  • <?=$post[

    The Fastener Factory Discount Hardware Supplies, .

    Find Anything You Need at Our Melbourne Location or at Our Online Hardware Store. The Fastener Factory is so much more than a fastener shop. As one of Australia's largest supplier of home improvement products, trade supplies and industrial hardware, we've expanded our product range to include everything from nuts and bolts to decking screws and fixings, safety gear, wire balustrade as .

    Chat Online
  • <?=$post[

    Stress Free Anchoring: Preparation tips and .

    I like to use a rope rode on the first anchor (with a length of chain at the anchor) and our chain (primary) rode on the second anchor. As we motor forward to drop the second anchor, I leave the first rode cleated off but pull in the slack by hand and let it pile up on deck, maintaining a little tension on the line.

    Chat Online
  • <?=$post[

    Fasteners - Hilti Ireland

    Drop-in, flush anchors with international approvals, available in carbon and stainless steel. Show more. Sleeve anchors and nail anchors. Metal anchor systems for fastenings in concrete, masonry and drywall. Show more. Plastic Anchors.

    Chat Online
  • <?=$post[

    Build a Climbing Wall Book | Atomik Climbing .

    Option #2 - Concrete Drop-in Anchor – This anchor is a little more sensitive to install, but at a quarter of the cost of the next option, many builders choose this option because of budget concerns. This anchor can only be used in solid concrete. Drill bit size for these 3/8-16 anchors is 1/2".

    Chat Online
  • <?=$post[

    CONCRETE ANCHORING SPECIALISTS DESCRIPTION/SUGGESTED ...

    Drop-In Anchors SELECTION CHARTS * 1 setting tool per master carton. ** For continuous extreme low temperature, use stainless steel. ***Embedment is equal to overall length of Drop-In Anchor Part No. Description RX-38 3/8" drop-in using 1/2" drill bit RTX-138 Setting Tool DCX-138 Depth Charge Stop Drill Part No. Description

    Chat Online
  • <?=$post[

    How to Drill Into Cast Iron | Hunker

    Cobalt bits are brass-colored. As an alternative, you can also use a gold-colored titanium nitride bit. In fact, any high speed steel bit intended for metal -- including all-purpose bits -- is suitable for cast iron. When using a drill press, you may find that a bit with a 118-degree point angle drills more smoothly and creates fewer shards.

    Chat Online
  • <?=$post[

    Nuts, Bolts, Concrete Anchors, Fixings and .

    Suppliers of nuts, bolts, Concrete anchor bolts and other fixings, UK Fixings Ltd is a family owned and operated business based in the heart of Sheffield, South Yorkshire. Established over 10 years ago, we have built our business on providing the best prices and service to some of Sheffields biggest and best manufacturing companies.

    Chat Online
  • <?=$post[

    Installing an Anchor Windlass | Cruising World

    The anchor chain feeds onto the gypsy and is pulled nearly all the way around it before it drops into a pipe or hole that leads it into the anchor locker. A benefit of this design is that nearly the entire gypsy is loaded with chain. This setup works fine with a single anchor rode, but cruisers often carry a spare anchor with a line and chain rode.

    Chat Online
  • <?=$post[

    SDS Plus Stop Bits |

    SDS Plus Stop Bits feature a large shoulder design for preventing over-depth drilling - crucial for drilling post-tensioned concrete. With a variety of diameters and lengths, these stop bits provide a solution for the most common anchor applications.

    Chat Online
  • <?=$post[

    SAFETY COVER SYSTEMS

    • Drill holes using 3/8" drill bit. Hole should be drilled 2-1/2" deep into masonry wall. Clear hole of any debris. Hole will be slightly deeper than anchor shaft. STEP 4: • Remove Cable Mate Wall Anchor from expansion casing. • Using the wall anchor tamping tool, tap the expansion casing into the 3/8.

    Chat Online
  • <?=$post[

    Drop in Anchor Stainless Steel - ukfixings

    Drop in anchors are a deformation controlled anchor suitable for use in concrete over C20/25. They are made from Stainless Steel to a grade of A4-314 and meet European Technical Approval ETAG 001 .

    Chat Online
  • <?=$post[

    Fixings & Fastener Specialist | Engineering & .

    Established in 1996, TC Fixings has grown from a small start-up, concentrating on the supply of fixings and fasteners, into a mature company with wide product choice, knowledgeable staff and a large showroom and stores. Located in Saffron Walden, Essex, TC Fixings offers a free van delivery service to the surrounding area and a free carrier service for the rest of the United Kingdom on orders ...

    Chat Online
  • <?=$post[

    Flush Anchors - Hilti Ireland

    Flush Anchors. Drop-in, flush anchors with international approvals, available in carbon and stainless steel All prices discounted net. 7 Products All prices discounted net. Overview More details Filter Start Over. 7 Products ...

    Chat Online
Contact us now